Difference between revisions of "Buffer Store Control"

Revision as of 13:07, 24 May 2022

Heat sources are assigned an order, representing the preferred order in which they fire, with 1 being the lead.
Uncontrolled heat sources, such as solar thermal, has an order of 0. Heat will be taken if available and there is space.
Heat sources with the same order will be run in duty/standby and rotated, pulling in the next in order as required.
Heat sources are fired up according to store depletion, both on volume remaining and rate of depletion.
Heat sources may be exercised after a period of inactivity, regardless of order.
Modulation will be applied to heat sources where possible to match loads and minimise cycling.
Low load buffering mode to minimise cycling.
Timing functions can be applied.
Includes functions for override of non-critical loads, such as central heating, when store close to empty.
Includes functions for activation of heat dump circuits for solar thermal and biomass.
Includes functions for boiler loading valve and pump control (with DP switch or sensor).
Includes alarm functions for low/high temperature, low/high pressure, low storage, failure of heat sources.
Makes possible the implementation of storage management and sequencing based on volatile fuel prices using predicted loads

The following schematic was generated using our open-source Heat Network Designer software.

@@ Line 1: / Line 1: @@
 == Functionality ==
-* Heat sources are assigned a priority, representing the preferred order in which they fire, with 1 being the lead.
+* Heat sources are assigned an order, representing the preferred order in which they fire, with 1 being the lead.
-* Uncontrolled heat sources, such as solar thermal, have a priority of 0. Heat will be taken if available and there is space.
+* Uncontrolled heat sources, such as solar thermal, has an order of 0. Heat will be taken if available and there is space.
-* Heat sources with the same priority will be run in duty/standby and rotated.
+* Heat sources with the same order will be run in duty/standby and rotated, pulling in the next in order as required.
 * Heat sources are fired up according to store depletion, both on volume remaining and rate of depletion.
-* Heat sources of lower priority will be exercised.
+* Heat sources may be exercised after a period of inactivity, regardless of order.
 * Modulation will be applied to heat sources where possible to match loads and minimise cycling.
 *Low load buffering mode to minimise cycling.